Shimano
Shimano Disc Brake SLX M7100 Kit - J-Kit 1700mm
Shimano Disc Brake SLX M7100 Kit - J-Kit 1700mm
Couldn't load pickup availability
SHIPPING INFORMATION
SHIPPING INFORMATION
Shipping Methods
Reliable delivery via GLS. Times vary by location.
Costs
Fees depend on destination and order value; free shipping for larger orders.
Tracking
Tracking numbers are emailed; use them to monitor your parcel.
Delays/Issues
Customer service helps with delays or lost parcels; re-shipping may occur if needed.
HOW TO TRACK MY ORDER?
HOW TO TRACK MY ORDER?
You can track your order using the tracking number sent to your email once your order has shipped. Simply go to the carrier’s website (GLS) enter your tracking number to see the delivery status.
If there are any delays or issues, contact customer service with your order number and tracking info for assistance.
SHIMANO SLX M7100 DISC BRAKE J-KIT - 1700mm
The SHIMANO SLX M7100 brake kit features the SERVO-WAVE system, offering outstanding and reliable performance while maintaining smooth operation. It includes a refined, ergonomic 2-finger lever that allows for precise braking control. The master cylinder and dual-piston caliper ensure powerful and dependable braking in all conditions. The M7100 lever also features an additional support point on the handlebar to enhance rigidity during braking.
Thanks to its I-SPEC clamp, installation is quick and does not require removing the grips. It also allows for a customized cockpit setup with a 20° adjustment angle for the shifter lever. The J-KIT system enables easy hose length adjustment before securing it to the master cylinder and/or simplifies internal cable routing.
SPECIFICATIONS
- Brake Type : Hydraulic disc brake
- Lever : BL-M7100 / Right-side / I-SP clamp / 2-finger design
- Caliper : BR-M7100 / Postmount / 2 pistons
- Hose : SM-BH90 - 1700mm
- J-KIT : Yes (hose is not pre-connected)
- Oil Type : Mineral
- Weight : 309g
BRAKE INSTALLATION
- - Position the brake lever on the handlebar.
- - Mount the caliper on the disc brake mount.
- - Remove the black rubber cap from the end of the hose.
- - Remove the plugs located at the end of the brake levers.
- - Slide the black rubber nut cover onto the hose.
- - Do not remove the small seal located at the end of the hose.
- - Insert the brake hose into the lever nut.
- - While ensuring the hose is fully seated in the lever nut, tighten the nut to compress the olive within the lever. Do not overtighten; the nut threading should remain visible, as it will later be covered by the rubber nut cover you slid onto the hose earlier.
- - Finally, activate the brake lever to complete the installation.
