• Shimano BL-MT501/BR-MT500 - J-KIT - 1550mm - Disc Brake Kit
1 1

Shimano

Shimano Disc Brake BL-MT501/BR-MT500 Kit - J-Kit 1700mm

Shimano Disc Brake BL-MT501/BR-MT500 Kit - J-Kit 1700mm

€79,99 EUR
€79,99 EUR
Sale Sold out
Taxes included.
Lever Type

SHIPPING INFORMATION

Shipping Methods
Reliable delivery via GLS. Times vary by location.

Costs
Fees depend on destination and order value; free shipping for larger orders.

Tracking
Tracking numbers are emailed; use them to monitor your parcel.

Delays/Issues
Customer service helps with delays or lost parcels; re-shipping may occur if needed.

HOW TO TRACK MY ORDER?

You can track your order using the tracking number sent to your email once your order has shipped. Simply go to the carrier’s website (GLS) enter your tracking number to see the delivery status.

If there are any delays or issues, contact customer service with your order number and tracking info for assistance.

SHIMANO BL-MT501/BR-MT500 DISC BRAKE J-KIT - 1700mm

The SHIMANO brake kit, featuring the BL-MT501 lever and BR-MT500 2-piston brake caliper, offers an excellent quality-to-price ratio.

Equipped with a SERVO WAVE brake, it delivers outstanding and reliable performance while maintaining smooth operation. The short, 2-finger lever is slim, ergonomic, and designed for precise braking control. The master cylinder and dual-piston caliper ensure powerful and dependable braking under all conditions.

Thanks to its I-SPEC clamp, installation is very quick and does not require removing the grips. The J-KIT system allows for adjusting the hose length before securing it to the master cylinder and/or simplifying internal cable routing.

SPECIFICATIONS

  • Brake Type : Hydraulic disc brake
  • Lever : BL-MT501 / Right Side / I-Spec clamp / 2-finger design
  • Caliper : BR-MT500 / Postmount / 2 pistons
  • Hose : SM-BH59 - 1700mm
  • J-KIT : Yes (hose is not pre-connected)
  • Oil Type : Mineral
  • Weight : 308g

BRAKE INSTALLATION

  • - Position the brake lever on the handlebar.
  • - Mount the caliper on the disc brake mount.
  • - Remove the black rubber cap from the end of the hose.
  • - Remove the plugs located at the end of the brake levers.
  • - Slide the black rubber nut cover onto the hose.
  • - Do not remove the small seal located at the end of the hose.
  • - Insert the brake hose into the lever nut.
  • - While ensuring the hose is fully seated in the lever nut, tighten the nut to compress the olive within the lever. Do not overtighten; the nut threading should remain visible, as it will later be covered by the rubber nut cover you slid onto the hose earlier.
  • - Finally, activate the brake lever to complete the installation.
View full details